Printronix SL5000E series User Manual page 264

Chapter 3
SERIAL PORT
The factory default is Disable.
Framing Errors
These are possible errors that can occur when serial interface settings of the
printer do not match those of the host computer.
•
Enable. If a framing error occurs, a fault message will display on the
control panel.
•
Disable. If a framing error occurs, a fault message will not display on the
control panel.
The factory default is Enable.
264
Table 10. ENQ Status Byte
Bit
0 Set when the label has printed.
1 Set when the label is presented.
2 Set while the printer is online.
3 Always set.
4 Set printing in the batch mode.
5 Set during a Ribbon fault.
6 Set during a Paper Out fault.
7 Set during a Head Open fault.
Printer Status