Printronix SL5000E series User Manual page 188

Chapter 3
P-SER XQ SETUP
P-SER XQ SETUP
(cont. from prev. page)
Control Code 06
(page 209)
Compressed Print
Char 01 SOH*
(page 208)
Bold
(page 200)
Elong/Alt. Font
Elng=BS Font=SO*
(page 212)
Gothic Typeface
Char 02 STX*
(page 217)
EVFU Select
(page 214)
Upr. Case Select
(page 244)
Slew Relative
(page 239)
Text Position
Bottom of Line*
(page 241)
Host Command
(page 219)
Reset Cmd CFG Ld
(page 234)
(1)(2)
Form Length
(page 216)
(1)(2)
Form Length
(page 216)
(1)
Form Length
(page 216)
(2)(4)
Form Width
04.1, 06.6, or 08.5 inches*
(page 217)
(2)(4)
Form Width
104.1, 168.0, or 215.9 mm*
(page 217)
(4)
Form Width
(page 217)
188
8.0 LPI* 10.3 LPI
Char 03 ETX
Disable* Enable
Elng=SO Font=BS
Char 03 ETX
Enable* Disable
Disable* Enable
1 to 15 lines* 1 to 16 lines
Top of Line
Enable* Ignore All Ignore CPI
Disable* Power up config
(3)
4 or 6 inches*
(3)
101.6 or 152.4 mm*
(3)
24 or 36 lines*
(3)
(3)
(3)
41, 66, or 85 characters*
6.0 LPI
Notes:
* = Factory Default
1
All three Form Length
Char 09 HT
submenus work in conjunction.
When you change the default
in one submenu, the default
values in the other two
submenus change
automatically.
2
These menus do not display
when the CT, TN5250, or
TN3270 emulation is selected.
Char 09 HT
3
The factory default value
depends on the width of the
printer model.
4
All three Form Width submenus
work in conjunction. When you
change the default in one
submenu, the default values in
the other two submenus
change automatically.
Ignore LPI
Current config
00.0 to 24.0 inches
00.0 to 609.6 mm
0 to 144 lines
00.0 to 13.6 inches
00.0 to 345.4 mm
0 to 272 characters
Factory config