Printronix SL5000E series User Manual page 266

Chapter 3
C/T PORT
Timeout
This item allows you to set the time that the printer, when it has not received
data from its host, will begin to service all other host ports looking for data to
print.
The range is 5-60 seconds, and the factory default is 10 seconds.
Report Status
When a fault condition occurs in the printer, normally only the active port
reports the fault to the host. With this item enabled, the port will report any
fault even when it is not the current, active port.
The options are Disable (the factory default) and Enable.
266