Quick Setup - Printronix SL5000E series User Manual

Chapter 3

QUICK SETUP

QUICK SETUP
QUICK SETUP
Print Intensity
Print Speed
Print Mode
Transfer*
Media Handling
Tear-Off Strip*
Paper Feed Shift
Label Length
Label Width
4.1, 6.6, or 8.5 inches*
Ver Image Shift
Hor Image Shift
Orientation
(6)
Gap/Mark Sensor
Auto Calibrate
Run Calibrate
(7)
Validator Funct.
Save Config.
Power-Up Config.
100
-3* -15 to 15
(1)
6 ips* 2-10 ips
Direct
Tear-Off
(2)
0.00 inches* -0.50 to X inches
(2)(4)
4 or 6 inches* 00.1 to 99.0 inches
(2)(4)
00.1 to 8.5 inches
(2)
-1.00 to X inches
0.00 inches*
(2)
0.00 inches* -1.00 to 1.00 inches
Portrait* Landscape
Disable* Mark
Enable* Disable
1* 1-8
Factory* 1-8
Peel-Off Cut
(3)
(5)
(4)
(3)
Inv. Portrait Inv. Landscape
Gap Advanced Gap
Notes:
* = Factory Default
1
Maximum value depends on the printer model width
(4, 6, or 8 inches) and printhead (203 or 300 dpi).
2
You can change the unit value from inches to
millimeters under Units (in MEDIA CONTROL) when
Admin User is enabled.
3
Based on the current value setting for the Label
Length (in QUICK SETUP), up to a maximum of
12.80 inches.
4
Maximum value depends on the width of the printer
model (see Appendix A, "Specifications").
5
Maximum value depends on model width and size of
DRAM installed (see Appendix A, "Specifications").
6
Gap/Mark Sensor and Paper Out Sensor work in
conjunction, as shown in Table 6 on page 134. If you
change the Gap/Mark Sensor or Paper Out Sensor,
you must recalibrate the media.
7
Appears only if a validator is installed.
Continuous
Advanced Notch