Printronix SL5000E series User Manual page 234

Chapter 3
Emulation Submenus
Reset Cmd CFG Ld
(From page 186, page 188, page 190, page 192, page 194.)
When the printer receives a host data stream reset command (ESC@ or
ESC[K) in addition to resetting printer variables, the selected configuration is
loaded.
•
Disable. The active emulation parameters are loaded when the reset
command is executed.
•
Power up config. The power-up configuration is loaded when the reset
command is executed.
•
Current config. The currently selected configuration is loaded when the
reset command is executed.
•
Factory config. The factory installed configuration is loaded when the
reset command is executed.
The factory default is Disable.
Resolution Mode
(From page 181.) The ^JM command determines the apparent print resolution
of the printed label. If half resolution mode is selected by the ^JM command,
the printed output of a 300 dpi printer matches that printed by a 150 dpi printer
(half resolution). This essentially doubles the size of the label image, including
label dimensions. If full resolution mode is selected, the output is printed
normally. The Resolution Mode option displays and selects the current setting
associated with the ^JM command.
The factory default is Full.
Right Margin
(From page 184, page 187, page 189, page 191, page 193.)
Set in characters. Character zero is defined as the far right edge of the page,
and column numbering increments from right to left.
The range is 0-369 characters, and the factory default is 0 characters.
Rot. Char Size
(From page 179.)
•
Adjusted. Rotated (clockwise/counterclockwise), expanded characters
have a different size than an unrotated character with the same size
parameters.
•
Not Adjusted. Rotated, expanded characters will be the same size as
unrotated characters with the same size parameters.
The factory default is Adjusted.
234