Printronix SL5000E series User Manual page 217

Form Width (char.)
(From page 186, page 188, page 190, page 192, page 194.)
The forms width can be specified as a function of the current CPI (characters
per inch). The forms width set should not exceed the actual paper width.
The factory default is the maximum printing width divided by the selected
number of characters per inch.
Form Width (in.)
(From page 186, page 188, page 190, page 192, page 194.)
In this submenu, form width is specified in inches. The form width set should
not exceed the actual paper width.
The factory default is the maximum printing width.
Form Width (mm.)
(From page 186, page 188, page 190, page 192, page 194.)
In this submenu, form width is specified in millimeters. The form width set
should not exceed the actual paper width.
The factory default is the maximum printing width.
Format Control
(From page 159, page 161, page 171, page 173.) Enables the printer to
reflect the same spacing as CTPC model printers after absolute and relative
move commands are executed.
•
Disable. Reflects distance, generated by the VGL feature, PGL feature,
and Hex Transparent control code sequence, in the new position (after
horizontal and vertical tabs are executed).
•
Enable. Does not reflect distance, generated by the VGL feature, PGL
feature, and Hex Transparent control code sequence, in the new position
(after horizontal and vertical tabs are executed).
The factory default is Disable.
Gothic Typeface
(From page 188.) Controls which host command sets high speed printing.
•
Char 02 STX
•
Char 03 ETX
•
Char 09 HT
The factory default is Char 02 STX.
Overview
217