NorthStar 961 Reference Manual page 77

WAYPTS/ROUTES
961/962 Operations and Reference Manual, Rev. A
Use the GO TO NEW COORDS key to:
• put new points in the trip (go to them now or add them to
the end of your trip)
Use the GO TO SELECTION key to:
• re-use existing points in the trip (active, past, or future
points)
Use the ERASURES key to:
• remove points from the trip (all points or only selected
ones)
Use the SAVE TRIP AS ROUTE key to:
• save the trip as a permanent route
Use the STOP NAV/RESUME NAV key (not shown if there isn't
an active waypoint) to:
• stop navigation alarms, waypoint sequencing, and
autopilot control, or else resume
Use the DATE-DIST/BRG-TIME key to:
switch the ARRIVAL column of the trip list between day
•
and time of arrival, day and date of arrival, and distance
and bearing between trip points along with the total trip
distance
For in-depth information about the trip function, see "Using
the Trip Function" starting on page 11-1.
Pressing the WAYPTS/ROUTES key lets you create new
waypoints, routes, tracks, and avoidance points; access, sort,
key
and edit lists of stored waypoints, routes, tracks, and avoidance
points; navigate to a stored waypoint; and follow a stored
route.
You can also create and store waypoints and routes directly from
CHART
the
CHART
on page 6-8. For information about creating routes from the
CHART
page 8-10.
NOTE:
screen. For more about creating waypoints from the
screen, see "Creating a new waypoint graphically" starting
screen, see "Creating a route as you travel" starting on
Chapter 3 - Using the Controls
Page 3-19