Erasing An Avoidance Point - NorthStar 961 Reference Manual

Chapter 7 - Creating Avoidance Points

Erasing an avoidance point

Page 7-14
4. Press the DONE key to store the avoidance point to the
avoidance point database (or press the CANCEL key to
cancel).
The CHART screen appears, showing the new radius of
the avoidance point and its position data in the CURSOR
INFO BAR.
On the CHART screen, you can edit an avoidance point by
changing its radius.
1. At the CHART screen, press the CURSOR PAD and if
necessary, the LEFT ARROW and RIGHT ARROW keys, to
select an avoidance point's radius, then press the
CURSOR menu key.
2. Press the EDIT key.
The CHART screen appears, showing the selected
avoidance point radius.
3. Press the CURSOR PAD to move the cursor and the
radius to the desired location.
4. Press the DONE key to store the new avoidance point
radius to the avoidance point database (or press the
CANCEL key to cancel).
The CHART screen appears, showing the avoidance
point's new radius and its position data in the CURSOR
INFO BAR.
At the AVOIDANCE POINTS screen, you can permanently
erase an avoidance point from the database:
1. At the AVOIDANCE POINTS screen, press the CURSOR
PAD up or down to select the desired avoidance point.
2. Press the EDIT key.
3. Press the ERASE AVOID key.
4. After you press the ERASE AVOID key, you're asked to
confirm this action before you proceed by pressing the
YES key (to cancel the erasure, press the NO key).
961/962 Operations and Reference Manual, Rev. A