NorthStar 961 Reference Manual page 227

961/962 Operations and Reference Manual, Rev. A
5. Press the GO NOW key.
The JOIN LEG dialog box appears, prompting you to
remember to press the SAVE key at the point where you
actually join the leg (a SAVE keypress will store that point
in the trip).
6. Press the OK key.
Navigation begins along the selected route leg, then
follows the rest of the route.
Adding a route to the end of your trip
You can add an entire route, or only part of a route, to the end
of your trip.
1. On the ROUTES screen, press the CURSOR PAD up or
down to select the desired route.
2. To display the route on the CHART screen, press the ON
CHART key, then press the CHART key.
3. On the CHART screen, press the CURSOR PAD to select
the starting point or starting leg of the route.
The name of the selected route must appear in the
CURSOR INFO BAR at the bottom of the screen; if
necessary, press the LEFT ARROW and RIGHT ARROW
keys. To add the entire route, select POINT 1 of the
desired route; to add only part of the route, select the
desired POINT and the route will be added starting at this
point. You also can select a route leg, and the system will
add the route starting at the beginning point of the
selected leg, including all subsequent legs and points.
4. Press the CURSOR menu key.
The SELECTED ROUTE LEG or SELECTED ROUTE
POINT dialog box appears, depending on whether you
selected a route point or a route leg.
5. Press the ADD TO END OF TRIP key.
The route is added to the end of your trip. If you were
already past the end of the existing trip, you'll immediately
begin navigating to the new route.
Chapter 10 - Waypoint and Route Navigation
Page 10-13