NorthStar 961 Reference Manual page 341

961/962 Operations and Reference Manual, Rev. A
To use the last position fix as a starting position, and start
demo mode, skip to step #3.
-or -
To use one of the stored waypoints as a starting position,
press the USE WAYPT key, then press the CURSOR PAD
to highlight a starting waypoint (if necessary, you can
search the waypoint list for a starting waypoint) in the
flashing red/green box. After you've highlighted a
waypoint, its lat/lon coordinates appear in the LATITUDE
and LONGITUDE fields at the bottom of the screen. To
edit these coordinates, press the EDIT key, and enter the
desired lat/lon, course, and speed.
-or-
To enter new lat/lon coordinates for your starting
position, press the CURSOR PAD left, right, up, and down
to separately highlight the LATITUDE and LONGITUDE
fields (the cursor defaults to the COURSE field), then edit
these fields as desired.
3. To simulate motion, enter course and speed in the
COURSE and SPEED fields at the bottom of the screen.
4. To start demo mode, press the START key.
A dialog box appears, asking if you want to enable NMEA/
PPNM outputs for the next 10 minutes.
5. To accept, press the YES key. To decline, press the NO key.
In either case, the CHART screen appears.
As with various other 961/962 screens, on this
MODE
screen, you can display a waypoint's position as either lat/
lon or Loran-C TDs: Press the
between lat/lon and TD readings.
Chapter 13 - Customizing Setup Functions
NOTE:
TDS,LAT/LON
SETUP DEMO
key to cycle
Page 13-71