NorthStar 961 Reference Manual page 199

961/962 Operations and Reference Manual, Rev. A
2. To display the route on the CHART screen, press the ON
CHART key, then press the CHART key.
3. Press the CURSOR PAD to move the cursor to the
position where you want to store the route's new end
point.
4. Press the CURSOR menu key, then press the STORE AS
WAYPT/ROUTE key.
5. If desired, enter a name for the new waypoint; otherwise,
the name defaults to starting sequentially as W0000.
6. Press the ADD TO END OF ROUTE key.
The CHART screen appears, showing a connecting route
leg from the old end point to the new end point.
7. To add any additional waypoints to the end of the route,
repeat step #3 through step #6.
Adding named waypoints to the end of a displayed route
First, on the ROUTES screen, remember to press the CURSOR
PAD up or down to select the desired route. To display the
route on the CHART screen, press the ON CHART key, then
press the CHART key.
1. At the CHART screen, press the CURSOR PAD to select
the named waypoint you want to add to the route. Note
that you may have to use the LEFT ARROW or RIGHT
ARROW key to select a named waypoint.
2. At the SELECTED WAYPOINT dialog box, press the ADD
TO END OF ROUTE key.
The CHART screen appears.
Graphically deleting route waypoints
To permanently delete waypoints from a route (but not from
the database of waypoints):
1. On the ROUTES screen, press the CURSOR PAD up or
down to select the desired route.
2. To display the route on the CHART screen, press the ON
CHART key, then press the CHART key.
Chapter 8 - Creating Routes
Page 8-23