NorthStar 961 Reference Manual page 198

Chapter 8 - Creating Routes
Page 8-22
4. Press the CURSOR menu key.
5. At the SELECTED ROUTE POINT dialog box, press the
EDIT key.
6. Press the CURSOR PAD to move the waypoint to the
desired location, then press the DONE key (or press
CANCEL to leave the waypoint unchanged).
The location of the moved route waypoint is displayed.
Graphically adding waypoints to a route leg
1. On the ROUTES screen, press the CURSOR PAD up or
down to select the desired route.
2. To display the route on the CHART screen, press the ON
CHART key, then press the CHART key.
3. At the CHART screen, press the CURSOR PAD to select
the desired leg of the route.
The name of the selected route and the particular leg
must appear in the CURSOR INFO BAR at the bottom of
the screen; to highlight the route leg, you may have to
press the LEFT ARROW and RIGHT ARROW keys.
4. Press the CURSOR menu key, then press the EDIT key.
5. Press the CURSOR PAD to move the cursor to the desired
location. If desired, you may select a named waypoint.
As you move the cursor, a light gray line indicates the
location of the new legs to and from the new waypoint.
6. To insert the new waypoint at the cursor position, press
the DONE key.
The CHART screen appears, showing the route leg's new
unnamed point (called POINT X in the CURSOR INFO
BAR).
7. To add waypoints to the same route leg or different route
legs, repeat steps #3 through #6.
Graphically adding waypoints to the end of a route
1. On the ROUTES screen, press the CURSOR PAD up or
down to select the desired route.
961/962 Operations and Reference Manual, Rev. A