Configuring Transit Node - 3Com Switch 4800G 24-Port Configuration Manual

1148 C 90: RRPP C
HAPTER
Master Node
Configuration Example
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] link-delay 0
[Sysname-GigabitEthernet1/0/1] quit
[Sysname] interface gigabitethernet 1/0/2
[Sysname-GigabitEthernet1/0/2] link-delay 0
[Sysname-GigabitEthernet1/0/2] quit
[Sysname] rrpp domain 1
[Sysname-rrpp-domain1] control-vlan 4092
[Sysname-rrpp-domain1] ring 1 node-mode master primary-port gigabitethernet 1/0/1 secondary-port gigabitethernet 1/0/2 level 0
[Sysname-rrpp-domain1] timer hello-timer 2 fail-timer 7
[Sysname-rrpp-domain1] ring 1 enable
[Sysname-rrpp-domain1] quit
[Sysname] rrpp enable
Configuring Transit
Node
Configuration Procedure
ONFIGURATION
To do...
Configure the timer for the
RRPP domain
Enable the RRPP ring
Return to system view
Enable RRPP
c
CAUTION:
The control VLAN configured for an RRPP domain must be a new one.
■
Control VLAN configuration is required for configuring an RRPP ring.
■
To use the undo rrpp domain command to remove an RRPP domain, you
■
must ensure the RRPP domain has no RRPP ring.
Network requirements
Specify the device in RRPP domain 1;
■
Set VLAN 4092 as the control VLAN;
■
Specify the device as the master node of primary ring 1 in RRPP domain 1,
■
GigabitEthernet 1/0/1 as the primary port and GigabitEthernet 1/0/2 as the
secondary port;
Set the Hello timer value to 2 seconds and the Fail timer value to 7 seconds.
■
Configuration procedure
Follow these steps to configure transit node:
To do...
Enter system view
Create an RRPP domain and
enter its view
Use the command...
timer hello-timer hello-value
fail-timer fail-value
ring ring-id enable
quit
rrpp enable
Use the command...
system-view
rrpp domain domain-id
Remarks
Optional
By default, the Hello timer
value is 1 second and the Fail
timer value is 3 seconds.
Required
By default, the RRPP ring is
disabled.
-
Required
By default, RRPP is disabled.
Remarks
-
Required