Replacing The Analog Interface Board - Ametek 5920 UHP User Manual

Replacing the Analog Interface Board

The Analog Interface board (AMETEK Part No. 591144902) is located between
the Motor Driver board and the MCU board at the rear of the Electronics Mod-
ule. Use Figure 4-11 to locate the Analog Interface board.
To remove the Analog Interface board:
1. Remove the Motor Driver board as described in the previous section.
2. Using a screwdriver, remove the two (2) screws from the standoffs that
3. Using the 1/16-inch hex wrench, remove the two (2) standoffs holding the
4. Unplug the connectors attached to the board (Figure 4-12).
To replace the Analog Interface board:
1. Position the Analog Interface board on the four (4) standoffs and attach
2. Using the 1/16-inch hex wrench, attach the two (2) standoffs that you
3. Plug in the Analog Interface board connectors.
4. Replace the Motor Driver board by positioning the board on the two (2)
5. Plug in the Motor Drive board connectors.
PN 592047901 Rev YC
hold the board in place.
board in place.
the two (2) screws you removed earlier. Do not overtighten.
removed earlier.
standoffs and replacing the screws removed earlier. Do not overtighten.
Maintenance and Troubleshooting | 4-21