Table of Contents
Advertisement
Parameters on the Device Communications tab include:
Baud Rate
RS-485
Saving Your Settings
To save settings on the Device Communications tab, click Apply.
To save settings and exit the program, click Apply+Exit.
To abort changes you have made, click Cancel+Exit. This will close the Con-
figurator Software program.
PN 592047901 Rev YC
Select the baud rate at which data will be transferred.
Identifies the analyzer's address and the type of serial communication
cable that is being used.
Address
Type the network address for the analyzer being connected.
Two-Wire RS-485
Click if you are using a 2-wire cable.
Four-Wire RS-485
Click if you are using a 4-wire cable.
|
Controller/Interface
3-17
Advertisement
Table of Contents
