Replacing The Motor Driver Board - Ametek 5920 UHP User Manual

Replacing the Motor Driver Board

The Motor Driver board (AMETEK Part No. 591053901) is located above the
Analog Interface board. Use Figure 4-11 to locate the Motor Driver board.
To remove the Motor Drive board:
1. After locating the Motor Driver board, use a screwdriver to remove the
2. Unplug connectors P-1 and P-2 from the board.
To replace the Motor Drive board:
1. Install the new Motor Driver board by placing it over the standoffs and
2. Plug connectors P-1 and P-2 into the board.
PN 592047901 Rev YC
two (2) screws that hold the board to the standoffs.
attaching with the screws you removed earlier. Do not overtighten.
Maintenance and Troubleshooting | 4-19