Working From The Setup Tab - Ametek 5920 UHP User Manual

Working From the Setup Tab

Use the Setup tab to define analyzer parameters.
Figure 3-10.
Setup tab.
Gas
4–20 mA Output
3-18 | 5920 UHP Moisture Analyzer
Select the gas being sampled.
Dewpoint Temp – If you select dewpoint temp, the Process Pressure
box is activated and you must enter a process pressure parameter in
kPa.
Set up your analog output range.
20 mA
Enter your high analog output limit.
4 mA
Enter your low analog output limit.
Hold during zero
Check this box to hold analyzer output during Verification and Zero.
PN 592047901 Rev YC