Assembling The Tilt Sensor - Dürkopp Adler D887 e-con Operating Instructions Manual

190

7.10 Assembling the tilt sensor

Fig. 101: Assembling the tilt sensor (1)
(1) - Sensor
To assemble the tilt sensor:
1. Tilt the machine over.
 The sensor (1) has been pre-assembled on the cover of
the pulley.
The magnet (2) and screws are in the bag that contains the
bobbins.
2. Screw the magnets (2) into the slot of the tabletop using
the screws ( p. 262).
Screw the magnet (2) in place opposite the sensor (1).
(2) - Magnet
Operating Instructions D887 e-con - 00.0 - 11/2023
Setup
①
②