Dürkopp Adler D887 e-con Operating Instructions Manual page 220

Code Type
2352 Error
2371 Error
2372 Error
2373 Error
2374 Error
2375 Error
2376 Error
2377 Error
2378 Error
2379 Error
2380 Error
2381 Error
218
Possible cause
Stepper card X50
overcurrent
Stepper card X50 watchdog
(Foot lifting)
Stepper card X50 motor
overload/overvoltage/over-
current (Foot stroke)
Stepper card X50 sewing
motor encoder not con-
nected (Foot stroke)
Stepper card X50 sewing
motor encoder not initialized
(Foot stroke)
Stepper card X50 init position
not found (Foot stroke)
Stepper card X50 not
enabled (Foot stroke)
Stepper card X50 overload
(Foot stroke)
Stepper card X50 encoder
failure (Foot stroke)
Stepper card X50 Current
sensor failure (Foot stroke)
Stepper card X50 Incorrect
stepping motor direction of
rotation (Foot stroke)
Stepper card X50 reference
drive failure (Foot stroke)
Corrective
• Check for stiff movement
• Perform software update
• Check selection of class
• Check selection of class
• Replace the control
• Replace encoder
• Replace stepper motor
• Replace the control
• Perform software update
• Check selection of class
• Check for stiff movement
• Replace encoder
• Replace motor
• Replace the control
• Check for stiff movement
• Replace encoder
• Replace motor
• Replace encoder
• Replace the control
• Replace encoder
• Check if plugs have been mixed up
• Check the wiring in the machine distribu-
tor and change it if necessary
• Check for stiff movement
• Replace encoder
• Replace motor
Operating Instructions D887 e-con - 00.0 - 11/2023
Troubleshooting