Dürkopp Adler D887 e-con Operating Instructions Manual page 236

Code Type
9352 Error
9353 Information Needle thread tension sen-
9354 Error
9360 Error
9361 Error
9362 Error
9370 Warning
9371 Warning
9372 Warning
9910 Warning
9911 Warning
9912 Warning
9913 Warning
9914 Warning
9915 Warning
234
Possible cause
Right thread tension pcb is
not connected
sor pcb not connected
Needle Transport PCB not
connected
Edge guide pcb is not
connected
Edge guide x-axis pcb is not
connected
Edge guide y-axis pcb is not
connected
Scanner module not
connected
Scanner module 24 V Error
Scanner module 5 V Error
Sewing stop
Power down
Restart necessary
Empty bobbin
Reset
Please Wait!
Corrective
• Check connection cables
• Perform software update
• Replace PCB
• Check connection cables
• Perform software update
• Replace thread tension sensor
• Check connection cables
• Perform software update
• Replace needle transport PCB
• Check connection cables
• Perform software update
• Replace PCB
• Check connection cables
• Perform software update
• Replace PCB
• Check connection cables
• Perform software update
• Replace PCB
• Check connection cables
• Perform software update
• Replace scanner module
• Check connection cables
• Check connected scanners
• Replace scanner module
• Stored analogue value for stroke
• Check tilt sensor on machine
• Check 24V
• Replace the control
• The control is switched off
• Switch off the control
• Please insert a full bobbin
• Remove USB key!
• Please wait and do not remove USB key
Operating Instructions D887 e-con - 00.0 - 11/2023
Troubleshooting