Dürkopp Adler D887 e-con Operating Instructions Manual page 123

Programming Commander DELTA
Icon Parameter
Adjustments for seam end bartack parameters
Number of stitches backwards
Number of stitches forward
Number of bartack sections
A bartack consists of several sections.
If the sewing direction is changed, a new
section is started. The number of sections
in a bartack can be set here.
Stop-Time for direction change
The waiting time at the turning points
(e.g. for a change of sewing direction) is set
at this point. A short waiting time in
milliseconds should ensure consistent
seam quality (ornamental-stitch bartack).
Stitch length default
If this function is active, the same needle
stitch length is used for the bartack as the
one set in Manual mode. If this function is
deactivated, a custom input can be
entered.
Sewing speed
Single stitches per pedal
If this function is activated, each stitch in the
bartack can be sewn individually by pressing
the pedal. This function can only be used
meaningfully if the speed is set very low for
the bartack.
Operating Instructions D887 e-con - 00.0 - 11/2023
Settings
Value range
01 – 50 [stitches]
Value range
01 – 50 [stitches]
Value range
01 – 99
Value range
0000 – 1000 [ms]
On/Off
Stitch length of backwards stitches
Value range
01.0 – 12.0 [mm],
(depending on subclass)
Stitch length of stitches forward
Value range
01.0 – 12.0 [mm],
(depending on subclass)
Value range
0050 – 2000 [rpm]
Value range
Off
With bartack speed
With pedal speed
121