Table of Contents
Advertisement
Icon
Parameter
Sewing foot lift at stop
Height of sewing foot lift at stop
Backwards
When the parameter is activated, the
section is sewn backwards.
Center guide
(only on two-needle machines, optional
additional equipment)
Puller
(optional additional equipment)
The puller supports the transport of the
sewing material. The feed of the two
rollers is calculated automatically based
on the stitch length of the machine.
An adjustment may be necessary
depending on the application.
The puller can be adjusted separately.
The input is in percent: a positive value
increases the roller feed while a negative
value reduces the feed.
Gap
(optional additional equipment)
The edge guide helps to precisely position
the sewing material. The value set
indicates the distance between the needle
and edge guide/material edge.
Light barrier
(optional additional equipment)
The light barrier detects the beginning
and the end of the material. After a signal
was detected, sewing can continue
automatically with the specifically set
parameters.
Thread tension sensor mode
(Access only after activation in
the machine configuration)
154
Programming Commander DELTA
Settings
Value range
On/Off
Value range
01 – 20 [mm]
(depending on subclass)
Value range
On/Off
Value range
On/Off
On/Off
Correction top roller
Value range
-100 – 100 [%]
Correction bottom roller
Value range
-100 – 100 [%]
Value range
08.0 – 45.0 [mm]
Value range
On/Off
( p. 157)
( p. 158)
Operating Instructions D887 e-con - 00.0 - 11/2023
Advertisement
Table of Contents
