Dürkopp Adler D887 e-con Operating Instructions Manual page 243

Troubleshooting
Operating Instructions D887 e-con - 00.0 - 11/2023
Error Possible causes
Skip stitches Needle thread and hook
thread have not been
threaded correctly
Needle is blunt or bent
Needle is not inserted cor-
rectly into the needle bar
The needle thickness used
is unsuitable
The reel stand is assem-
bled incorrectly
Thread tensions are too
tight
Throat plate or hook have
been damaged by the
needle
Distance from the hook
to the needle is not set
correctly
Loose stitches Thread tensions are not
adjusted to the sewing
material, the sewing mate-
rial thickness or the thread
used
Needle thread and hook
thread have not been
threaded correctly
Needle Needle thickness is unsuit-
breakage able for the sewing mate-
rial or the thread
Corrective
Check threading path
( p. 25,  p. 38).
Replace the needle
( p. 22).
Insert the needle correctly
into the needle bar
( p. 22).
Use recommended needle
thickness ( p. 244)
Check the assembly of
the reel stand
Check thread tensions
( p. 40).
Have parts reworked by
qualified specialists
Set the correct distance
( Service Instructions)
Check thread tensions
( p. 40).
Check threading path
( p. 25,  p. 38).
Use recommended needle
thickness ( p. 244).
241