Dürkopp Adler D887 e-con Operating Instructions Manual page 232

Code Type
8129 Error
8130 Error
8131 Error
8132 Error
8133 Error
8135 Error
8136 Error
8151 Error
8154 Error
8156 Error
8157 Error
8158 Error
8159 Error
8162 Error
230
Possible cause
Stepper Puller Top Incorrect
stepping motor direction of
rotation
Stepper Puller Top reference
drive failure
Stepper Puller Top
overcurrent
Stepper Puller Top parameter
initialization
Stepper Puller Top insulation
error
Stepper Puller Top transport
interval failure
Stepper Puller Top reference
drive failure
Stepper Puller Bottom refer-
ence drive timeout
Stepper Puller Bottom step-
per motor blockage
Stepper Puller Bottom
encoder plug not connected
Stepper Puller Bottom fly-
wheel position not found
Stepper Puller Bottom not
responding
Stepper Puller Bottom not
responding
Stepper Puller Bottom
overcurrent
Corrective
• Replace encoder
• Check if plugs have been mixed up
• Check the wiring in the machine distribu-
tor and change it if necessary
• Check for stiff movement
• Replace encoder
• Replace motor
• Replace the control
• Perform software update
• Check selection of class
• Check motor phase and PE for low-
impedance connection
• Replace encoder
• Replace motor
• Perform software update
• Check selection of class
• Check for stiff movement
• Replace encoder
• Replace motor
• Check reference sensor
• Check for stiff movement
• Connect encoder cable to the control, use
correct connection
• Check stepper motor 1 for stiff movement
• Perform software update
• Replace the control
• Perform software update
• Replace the control
• Check for stiff movement
Operating Instructions D887 e-con - 00.0 - 11/2023
Troubleshooting