Dürkopp Adler D887 e-con Operating Instructions Manual page 55

Operation
Operating Instructions D887 e-con - 00.0 - 11/2023
Status Processes
At seam beginning
Start bartack • Press the pedal forwards (position +1) and keep it
and sew there.
Machine sews a start bartack (if specified).
Afterwards, the machine continues to sew - with
increasing speed the further forward the pedal is
pressed.
In the middle of the seam
Stop sewing • Release the pedal (position 0).
The machine stops. Depending on the setting,
the roller foot is either up or down.
Continue • Press the pedal forwards (position +1)
the sewing Machine continues to sew - with increasing speed
process (after the further forward the pedal is pressed.
releasing the
pedal)
Sewing over • Use the knee button to increase the roller foot stroke
thicker parts ( p. 47).
of the material
Changing the • Activate the 2
stitch length the push button panel ( p. 47).
Increasing the • Use the button on the push button panel to activate
thread tension the additional thread tension ( p. 47).
Sewing an • Sew backwards with stitch regulator ( p. 47)or acti-
intermediate vate backwards sewing using the button on the push
bartack button panel ( p. 47).
At seam end
Finish the • Press the pedal fully back (position -2) and keep it
seam and there.
remove End bartack is sewn, and thread is cut (if set).
the sewing Machine stops.
material Needle is up. Roller foot is up.
• Remove the sewing material.
nd
stitch length using the button on
53