Dürkopp Adler D887 e-con Operating Instructions Manual page 148

146
5.9.5.4 Setting the Correction speed effect parameters
Some parameters are affected by high speeds because of the
resulting physical effects. To counteract these effects and to
achieve consistent results, even at high speeds, adjustment
factors can be set depending on the speed.
Overview of setting modes
The correction of the effects of high speeds can be identified in
various modes and responded to depending on the setting.
This general explanation can be applied to the following specific
parameters.
Setting mode
Linear
2. Value
On/Off
2. Value
On
Programming Commander DELTA
Description
In the linear setting, the size of the parameter
increases or decreases steadily as the speed
increases. The increase/decrease of the parameter
depends on the limits set for the minimum and
maximum speed.
If a certain speed is exceeded, the second value of
the parameter is activated. If the speed then falls
below this level again, it switches to the base value
for the parameter.
If a certain speed is activated, the second value of
the parameter is activated. If the speed then falls
below this level again, it does NOT switch to the
base value for the parameter. Only after finishing
the seam by cutting the thread is the base value for
the parameter set again.
Operating Instructions D887 e-con - 00.0 - 11/2023