Table of Contents
Advertisement
Icon
Parameter
Stop-Time for direction change
The waiting time at the turning points (e.g. for
a change of sewing direction) is set at this
point. A short waiting time in milliseconds
should ensure consistent seam quality
(ornamental-stitch bartack).
Stitch length default
If this function is active, the same needle
stitch length is used for the bartack as the
one set in Manual mode. If this function is
deactivated, a custom input can be entered.
Sewing speed
Single stitches per pedal
If this function is activated, each stitch in the
bartack can be sewn individually by pressing
the pedal. This function can only be used
meaningfully if the speed is set very low for
the bartack.
Needle thread tension default
If this function is active, the same needle
thread tension is used for the bartack as the
one set in Manual mode. If this function is
deactivated, a custom input can be entered.
160
Programming Commander DELTA
Settings
Value range
0000 - 1000 [ms]
On/Off
Stitch length of stitches forward
Value range
01.0 – 12.0 [mm]
(depending on subclass)
Stitch length of backwards stitches
Value range
01.0 – 12.0 [mm]
(depending on subclass)
Value range
0050 – 2000 [rpm]
Value range
Off
With bartack speed
With pedal speed
Value range
On/Off
Operating Instructions D887 e-con - 00.0 - 11/2023
Advertisement
Table of Contents
