Dürkopp Adler D887 e-con Operating Instructions Manual page 138

Icon Parameter
Bobbin monitor mode
Counter Mode
Daily piece counter, can be set to count
either up or down.
Point position
The distance of the needle from the
material can be adjusted to allow
precise positioning of the sewing
material when starting sewing.
The value entered corresponds to the
degree number on the handwheel.
Flat Sew
Transport correction at zero difference
for Flat Sew
Material thickness detection
Material thickness detection
Sewing foot stroke
Stitch length
Needle thread tension
136
Programming Commander DELTA
Settings
( p. 139)
Off/Up/Down
Reset
When the daily piece counter is
activated, it must be reset once after
entering a value to ensure it counts
correctly.
Value range
000–359 [°]
Value range
-20 – 20
Value range
On/Off
( p. 146)
The sewing foot stroke can be adjusted
to different material thicknesses by the
software.
The stitch length changes slightly
depending on the material thickness.
For this reason, the stitch length can
be adjusted to different material
thicknesses by the software.
Depending on the material thickness,
the needle thread tension can be
adjusted to different material
thicknesses by the software.
Operating Instructions D887 e-con - 00.0 - 11/2023