Dürkopp Adler D887 e-con Operating Instructions Manual page 240

Code Type
9965 Warning
9966 Warning
9967 Warning
9968 Warning
9969 Warning
9970 Warning
9971 Warning
9972 Warning
9973 Warning
9974 Warning
9975 Warning
9976 Information Daily piece counter reached • Daily piece counter reached
9977 Warning
9978 Information • Poka Yoke Function 1
238
Possible cause
Select target position
Thread Tension too low
(Warning)
Edge Guide in Wrong
Position
PQS not connected
Thread Tension too high
(Warning)
The limit values of the thread
tension have been exceeded
too often!
The thread tension value
does not change. The thread
may be broken or the connec-
tion to the sensor is lost.
Scan required
Another scan required
Scan again as RFID tags did
not match
Scan canceled
Switch off collision
protection
Corrective
• Select target position
• Thread Tension too low (Warning)
• Edge Guide must be in the right position
• PQS is activated but not connected,
please check the connection to the PCB
or call the DA service
• Thread Tension too high (Warning)
• The limit values of the thread tension
have been exceeded too often!
• The thread tension value does not
change. The thread may be broken or the
connection to the sensor is lost.
• Please scan the RFID tag
• Please scan the same RFID tag again
• Please scan the same RFID tag as before
• Please scan the same RFID tag again
• Attention: The electronic edge guide is
protected by safety zones to prevent colli-
sions. By activating this function, you are
switching off this collision protection.
There is an increased risk of the edge
guide colliding with other components of
the machine.
The system is waiting for a release of Poka
Yoke Function 1.
Operating Instructions D887 e-con - 00.0 - 11/2023
Troubleshooting