Table of Contents
Advertisement
Troubleshooting
Code
Type
9916
Warning
9917
Warning
9918
Warning
9919
Warning
9920
Warning
9921
Warning
9922
Warning
9923
Warning
9924
Warning
9925
Warning
9926
Warning
9927
Warning
9928
Warning
9929
Warning
9930
Warning
9931
Information Bobbin Wind mode
9932
Information No program available
9933
Information Continue with actual value? • Shall the bobbin winder continue with the
9934
Warning
Operating Instructions D887 e-con - 00.0 - 11/2023
Possible cause
Erase internal Memory
Erase USB key
No USB key present
Sewing stop
Referencing
Show Message from
QONDAC
Service Stop
Update required
Security key generated
Security Key changed!
Please Confirm Reset
Reset
Referencing?
Not enough thread available • Please insert a full bobbin
Empty bobbin
Tilt sensor active
Corrective
• Delete the SD card. Continue with OK;
cancel with ESC
• Delete the USB key. Continue with OK;
cancel with ESC
• Please insert USB key
• Machine in stop mode for threading
the thread
• Please wait for motor referencing
• Show Message
• Check the Service Stop button
• Check 24V
• Replace the control
• Press OK for Restart or ESC for cancel
• Creation of a security key on a USB key
• Overwrite Security Key?
• Really reset?
• Reset successfully
• Press pedal backwards (pedal position-2)
• Please insert a full bobbin
• Press pedal backwards exit bobbin wind
mode
• Automatic mode is not available without a
program. Please use programming mode
to define a program.
actual value (Press YES), or shall the
bobbin winder restart with a new bobbin
(Press NO)?
• Tilt sensor active
235
Advertisement
Table of Contents
