Dürkopp Adler D887 e-con Operating Instructions Manual page 137

Programming Commander DELTA
Icon Parameter
Additional value needle thread tension (+)
The second value for the needle thread
tension can be switched on using the
buttons on the push button panel or the
tile on the control panel.
Gap (second value)
The second value for the gap can be
switched on using the button on the
push button panel or the tile on the
control panel.
Program Cycle
Next program
A subsequent program can be defined.
Input via program number.
Program Cycle
The program is executed as a loop,
which is useful, for instance, for
ornamental stitch seams.
You select the start segment and the
end segment from a program and
define how often you wish the selected
segments to be sewn.
Main Parameter
Needle thread clamp
The needle thread clamp is closed at
the 1
the needle thread lies on the underside
of the sewing material
Needle cooling
Activate needle cooling.
Operating Instructions D887 e-con - 00.0 - 11/2023
st
stitch of the seam to ensure that
Settings
Value range
01 – 99[%]
Value range
08.0 – 45.0 [mm]
On/Off
Start Segment
Value range 00 – 30
(0 = the cycle starts with the first
segment)
End Segment
Value range 00 – 30
(0 = the cycle ends with the last
segment)
Repetitions
Value range 00 – 99
(0 = the cycle continues until the next
segment is activated manually)
Value range
On/Off
Value range
On/Off
135