Dürkopp Adler D887 e-con Operating Instructions Manual page 117

Programming Commander DELTA
Operating Instructions D887 e-con - 00.0 - 11/2023
5.7.3.4 Function modules
This parameter provides virtual switches that can be assigned
customer-specific functions. They can be used when customer-
specific applications require a signal from the control of the machine.
This parameter cannot be used unless the function modules have
been assigned to a physical output at the Technician level. This
requires that the parameter Module management be configured at
the Technician level; for more details, refer to the explanation in
the ( Service Instructions).
It is possible for each function module to place one function tile
(stored) on the main screen ( p. 94).
Menu item Setting 1
Function modules 1 - 8
Material thickness
Only visible in the mode
Material thickness.
The function module
becomes active starting with
the entered limit.
5.7.3.5 Setting the Output parameter
This parameter provides virtual outputs that can be assigned
customer-specific functions. They can be used when customer-
specific applications require a signal from the control of the
machine.
This parameter cannot be used unless the virtual outputs have
been assigned to a physical output at the Technician level.
This requires that the parameter Additional I/O Configuration be
configured at the Technician level; for more details, refer to the
explanation in the ( Service Instructions).
Setting 2
Value range
Material thickness/input
Value range
00 – 10 [rpm]
(depending on subclass)
115