Dürkopp Adler D887 e-con Operating Instructions Manual page 141

Programming Commander DELTA
Operating Instructions D887 e-con - 00.0 - 11/2023
5.9.5.2 Setting the Bobbin monitor mode parameters
The amount of remaining thread on the bobbin can be monitored
optically or by software using this setting.
Menu item
Off
Monitor
Monitor mode can
only be used if the
additional equipment
of the remaining
thread monitor is
present on the
machine.
Monitor mode allows
for optical monitoring
of the bobbin.
Setting 1
Sewing stop
Sewing stops and a notice is
shown on the display when
the bobbin is detected to be
nearly empty. If the
parameter is not activated,
only the LEDs on the
machine arm give a warning
if the bobbin is empty.
Sewing foot lower position
t Clean
Duration for which the lens is
blown clear with compressed
air. The process takes place as
the thread is cut.
Setting 2
Value range
On/Off
Value range
On/Off
Value range
0000–5000 [ms]
139