Disassembling The Ring Bolt; Assembling The Tilt Sensor - Dürkopp Adler D869 e-con Operating Instructions Manual

Setup
Operating Instructions D869 e-con - 00.0 - 06/2023
7.9

Disassembling the ring bolt

Fig. 75: Disassembling the ring bolt
①
②
(1) - Ring bolt
To disassemble the ring bolt:
1. Loosen the screw (2).
2. Remove ring bolt (1) and washer.
3. Re-tighten the screw (2).

7.10 Assembling the tilt sensor

Fig. 76: Assembling the tilt sensor
(1) - Sensor
The tilt sensor has been pre-assembled.
(2) - Screw
(2) - Magnet
①
②
157