IAI SW-4000T-MCL User Manual page 117

SW-4000T-MCL User Manual (2.0)
Item
Image Processing
Operation Mode
Trigger Inputs
Synchronous output (when
the terminal is open)
Communication interface
Field Update
Power Supply Voltage
(12-pin)
Lens mount
Flange back
Verified Performance
Temperature/Humidity
Storage
Temperature/Humidity
Vibration Resistance
Shock Resistance
Regulations
Housing
Weight
1. Pixel sensitivity correction: Pixel correction (DSNU, PRNU)
2.Shading correction: ColorShading, FlatShading
3. LUT: OFF: γ = 1.0, ON: 257 points can be set
4. Gamma: 0.45, 0.5, 0.55, 0.6, 0.65, 0.75, 0.8, 0.9, 1.0 (9 steps available)
5. Noise reduction: MEDIAN, FLIR, NoiseReduction
Exposure Mode : Off (Internal/External trigger)
Exposure Mode : Timed (Internal/External trigger)
Exposure Mode : TriggerWidth
TTL Input (12-pin and 10-pin)
Camera Link: LVDS (CC1)
Positive / negative logic switchable.
Minimum trigger width: CameraLink 3μs / TTL In 50ns
Camera Link: LVAL (Camera Link Tx24, DVAL (Camera LinkTx25), ExposureActive (Camera Link
Tx26)
12-pin: Exposure Active or LVAL
10-pin: Exposure Activeor LVAL
EIA-644: Camera Link (SerTFG, SerTC)
Communication Rate: 9600 bps, 19200 bps, 38400 bps, 57600 bps, 115200 bps
Supported
Input Range: DC +12 ~ +24V ± 10%
Power Consumption:9.3 W (at 12 V input, full pixel, Default setting, Environmental temperature
25°C) (Typical), 14.5W (Maximum)
M52 Mount, F mount
M52 mount: 46.5 mm (in air), tolerance: 0 mm to –0.05 mm
F mount: 46.5 mm, tolerance: 0 mm to –0.05 mm
-5°C ~ +45°C (20 to 80%, non-condensing)
Note: It may change depending on the installation environment. Please refer to the Caution in this chapter.
-25°C ~ +60°C (20 to 80%, non-condensing)
3G (20 Hz ~ 200 Hz X-Y-Z direction)
50G
CE (EN61000-6-2, EN61000-6-3), RoHS/WEEE, FCC Part15 Class B
90mm x 90mm x 90mm (WHD, excluding connectors)
765g
RGB
- 117 -
Miscellaneous