IAI SW-4000T-MCL User Manual page 105

SW-4000T-MCL User Manual (2.0)
Pulse Generator Name
PulseGeneratorClearActivation
[PulseGenerator1]
PulseGeneratorClearActivation
[PulseGenerator2]
PulseGeneratorClearActivation
[PulseGenerator3]
PulseGeneratorClearSource
[PulseGenerator0]
PulseGeneratorClearSource
[PulseGenerator1]
Short
Access
ASCII
0: Off
1: Level High
R/W PGCM1 2: Level Low
4: Rising Edge
8: Falling Edge
0: Off
1: Level High
R/W PGCM2 2: Level Low
4: Rising Edge
8: Falling Edge
0: Off
1: Level High
R/W PGCM3 2: Level Low
4: Rising Edge
8: Falling Edge
0: Low
1: High
7: ExposureActive
9: LVAL
10-13: PulseGenerator0-3
14-17: UserOutput0-3
20: Line4: TTL In1
21: Line5: Opt In1
23: Line7 - CC1
R/W PGIN0
24: Line10: TTL In2
26: NAND0 Out
27: NAND1 Out
28: Line13: TTL In3
29: EncoderTriger
30: EncoderDirection
Note: 10:
PulseGenerator0 cannot
be selected.
Same as PGIN0
R/W PGIN1
Note: 11:
PulseGenerator1 cannot
be selected.
- 105 -
Default
Values
Value
0
0
0
0
0
Short ASCII Command List
Example / Description
PGCM1 =[Param.]<CR><LF>
PGCM1 ?<CR><LF>
Set the clear signal condition for
the count clear input of
PulseGenerator1.
PGCM2 =[Param.]<CR><LF>
PGCM2 ?<CR><LF>
Set the clear signal condition for
the count clear input of
PulseGenerator2.
PGCM3 =[Param.]<CR><LF>
PGCM3 ?<CR><LF>
Set the clear signal condition for
the count clear input of
PulseGenerator3.
PGIN0=[Param.]<CR><LF>
PGIN0?<CR><LF>
Select the count clear input
signal source for
PulseGenerator0.
PGIN1=[Param.]<CR><LF>
PGIN1?<CR><LF>
Select the count clear input
signal source for
PulseGenerator1.