IAI SW-4000T-MCL User Manual page 104

SW-4000T-MCL User Manual (2.0)
Pulse Generator Name
PulseGeneratorEndPoint
[PulseGenerator3]
PulseGeneratorRepeatCount
[PulseGenerator0]
PulseGeneratorRepeatCount
[PulseGenerator1]
PulseGeneratorRepeatCount
[PulseGenerator2]
PulseGeneratorRepeatCount
[PulseGenerator3]
PulseGeneratorClearActivation
[PulseGenerator0]
Short
Access
ASCII
R/W PGEN3 0 ~ 1048575
R/W PGRPT0 0 ~ 255
R/W PGRPT1 0 ~ 255
R/W PGRPT2 0 ~ 255
R/W PGRPT3 0 ~ 255
0: Off
1: Level High
R/W PGCM0 2: Level Low
4: Rising Edge
8: Falling Edge
- 104 -
Default
Values
Value
0
0
0
0
0
0
Short ASCII Command List
Example / Description
PGEN3=[Param.]<CR><LF>
PGEN3?<CR><LF>
Set the start point of the Low
interval as a clock count for
PulseGenerator3. When the
counter reaches this value, the
output will be 0.
PGRPT0=[Param.]<CR><LF>
PGRPT0?<CR><LF>
Set the repeat count for the
counter for PulseGenerator0.
When this is set to 0, a free
counter is enabled with no
repeat limit.
PGRPT1=[Param.]<CR><LF>
PGRPT1?<CR><LF>
Set the repeat count for the
counter for PulseGenerator1.
When this is set to 0, a free
counter is enabled with no
repeat limit.
PGRPT2=[Param.]<CR><LF>
PGRPT2?<CR><LF>
Set the repeat count for the
counter for PulseGenerator2.
When this is set to 0, a free
counter is enabled with no
repeat limit.
PGRPT3=[Param.]<CR><LF>
PGRPT3?<CR><LF>
Set the repeat count for the
counter for PulseGenerator3.
When this is set to 0, a free
counter is enabled with no
repeat limit.
PGCM0 =[Param.]<CR><LF>
PGCM0 ?<CR><LF>
Set the clear signal condition for
the count clear input of
PulseGenerator0.