Number Of Pixels Per Line And Line Rate - IAI SW-4000T-MCL User Manual

3 cmos prism line scan camera with mini camera link interface

Table of Contents

SW-4000T-MCL User Manual (2.0)

Number of Pixels per Line and Line Rate

You can increase the line rate by decreasing the number of pixels per line. Use Width (ASCII =

WTC) to set the line width. Line rate can be increased to a maximum of 183.4 kHz for each

configuration.

The relationship between the number of pixels per line and the line rate for each CL configuration

is shown below. Widths smaller than the minimums shown will also run at 183.4 kHz.

Note: It becomes the line rate in the case of CameralinkClockFrequency 85MHz,

PixelFormat RGB8, ExposureMode Off. The maximum line rate varies depending on

operating conditions.

- 50 -

Main Functions

Table of Contents