IAI SW-4000T-MCL User Manual page 91

SW-4000T-MCL User Manual (2.0)
Analog Control
Access
Name
AWBExposureOnce
Status
AWBOnceStatus
BlackLevel
R/W
[DigitalAll]
BlackLevel
R/W
[DigitalRed]
BlackLevel
R/W
[DigitalBlue]
GainAuto R/W
AGCReference R/W
AGCOnceStatus
Short
Values
ASCII
1=Succeeded.
2=Error1 - G image was too
bright.
3=Error2 - G image was too
R AHRS
dark.
4=Error3 - Timeout-error
occurred.
5=IDEL
1=Succeeded.
2=Error1 - G image was too
bright.
3=Error2 - G image was too
R AWRS
dark.
4=Error3 - Timeout-error
occurred.
5=IDEL
BL -133 ~ 255
BLR -64 ~ 64
BLB -64 ~ 64
0:Off
AGC
1:Once
30 ~ 95
AGCR
Unit: %
1: Succeeded.
2: Error1 - Timeout-error
occurred.
R AGCS
3: Abort1 - Contro lLimit
4: Idle
Default
Value
AWHS?<CR><LF>
-
Displays the status at the time of execution
(BalanceWhiteAuto=ExposureOnce).
AWBS?<CR><LF>
-
Display the status when BalanceWhiteAuto is
set to Once,
BL=[Param.]<CR><LF>
BL?<CR><LF>
0
Controls the analog black level as an absolute
physical value. This represents a DC offset
applied to the video signal.
BLR=[Param.]<CR><LF>
BLR?<CR><LF>
0
Set BlackLevel[Red].
BLB=[Param.]<CR><LF>
BLB?<CR><LF>
0
Set BlackLevel[Blue].
AGC=[Param.]<CR><LF>
AGC?<CR><LF>
0
Enable/disable gain auto adjustment. Once
automatically changes to Off when the signal
level converges once.
AGCF=[Param.]<CR><LF>
AGCF?<CR><LF>
50
Set the target level for AGC.
AGCS?<CR><LF>
4
Display the status when GainAuto is set to
Once.
- 91 -
Short ASCII Command List
Example / Description