Introduction; Purpose Of This Operating Guide; Additional Resources; Manual Version - Danfoss D9h Operating Manual

VLT® AutomationDrive FC 302
Operating Guide

1 Introduction

1.1 Purpose of this Operating Guide

This Operating Guide provides information for safe installation and commissioning of the AC drive. It is intended for use by qualified
personnel.
Read and follow the instructions to use the drive safely and professionally.
Pay particular attention to the safety instructions and general warnings. Always keep this Operating Guide with the drive.
VLT is a registered trademark for Danfoss A/S.
®

1.2 Additional Resources

Other resources are available to understand advanced drive functions and programming.
• The Programming Guide provides detailed information on the LCP, menu system, parameters, and troubleshooting with alarms
and warnings.
• The Design Guide provides detailed information about capabilities and functionality to design motor control systems.
• The Safe Torque Off Operating Guide provides detailed specifications, requirements, and installation instructions for the Safe
Torque Off function.
• Supplementary publications and manuals are available from Danfoss, see www.danfoss.com.

1.3 Manual Version

This manual is regularly reviewed and updated. All suggestions for improvement are welcome.
The original language of this manual is English.
Table 1: Manual and Software Version
Version
AQ262139143212 - 0301
MG80F1xx

1.4 Approvals and Certifications

The following list is a selection of possible type approvals and certifications for Danfoss drives:
The specific approvals and certification for the enclosed drive or drive module are on the nameplate of the drive. For more informa-
tion, contact the local Danfoss office or partner.
8 | Danfoss A/S © 2021.10
Remarks
Updated split shipment content, added CE certification, added addl sine wave
and line reactor power loss tables.
First version
089
Introduction
Software version
8.43
8.23
AQ262139143212en-000301 / 130R0879