Enabling Motor Operation; Selecting The Voltage/Current Input Signal - Danfoss D9h Operating Manual

VLT® AutomationDrive FC 302
Operating Guide
Table 72: Recommended Fuse Ratings for UL Installation, 525–600 V
Drive model Fuse P/N (Mersen)
N90K A4J175
N110 A4J200
N132 A4J250
N160 A4J350
N200 A4J400
N250 A4J500
N315 A4J600
N355 A4J1600
N400 A4BY650
N500 A4BY750
N560 A4BY800
N630 A4BY1000
N710 A4BY1000

5.10 Enabling Motor Operation

If the status line at the bottom of the LCP reads AUTO REMOTE COAST, the unit is ready to operate but is missing an input signal
from terminal XD2.14 in the control compartment. Digital input terminal XD2.14 is designed to receive a 24 V DC external interlock
command that allows the drive to operate when using factory default programming values.
FACTORY-INSTALLED OPTIONAL EQUIPMENT
Do not remove factory-installed wiring to terminal XD2.14. If the drive does not run, refer to the documentation for the optional
equipment that is wired into terminal XD2.14.
Procedure
1.
When no interlock device is used, use a push-in type jumper (WAGO 2002-433) between terminal XD2.11 and XD2.14 in the
control compartment. This wire provides an internal 24 V signal on terminal XD2.14. The drive is ready for operation.

5.11 Selecting the Voltage/Current Input Signal

The analog input terminals XD2.7 and XD2.8 in the control compartment allow setting of input signal to voltage (0–10 V) or current
(0/4–20 mA).
• Terminal XD2.7: Speed reference signal in open loop (see parameter 16-61 Terminal 53 Switch Setting).
• Terminal XD2.8: Feedback signal in closed loop (see parameter 16-63 Terminal 54 Switch Setting).
Procedure
1. Disconnect power to the drive.
2. Remove the LCP (local control panel).
3. Remove any optional equipment covering the switches.
110 | Danfoss A/S © 2021.10
Fuse P/N (Danfoss) Maximum cur-
rent [A]
70CPE10971 175
70CPE10521 200
70CPE10972 250
70CPE10966 350
70CPE10522 400
70CPE10968 500
70CPE10523 600
70CPE10523 600
70CPE110003 650
70CPE10969 750
70CPE10974 800
70CPE10975 1000
70CPE10976 1100
N O T I C E
Electrical Installation
Maximum fuse Minimum volt-
rating F1 [A] age rating [V]
175 600
200 600
250 600
350 600
400 600
500 600
600 600
600 600
650 600
750 600
800 600
1000 600
1100 600
AQ262139143212en-000301 / 130R0879
Class F1
Class J
Class J
Class J
Class J
Class J
Class J
Class J
Class J
Class L
Class L
Class L
Class L
Class L