Connecting The Drive Module To The Motor - Danfoss D9h Operating Manual

VLT® AutomationDrive FC 302
Operating Guide
1
2
3
4
5
Illustration 57: Connection Points for Mains to Input Power Option (Enclosed Drive Configured With Power Options Cabinet)
1 Factory cables connecting contactor to drive input
terminals
2 Upper cover
3 Lower cover

5.8.3 Connecting the Drive Module to the Motor

Procedure
1. Strip a section of the outer cable insulation.
2. Fasten a connector/cable lug to the end of the stripped cable.
3. Create an electrical connection between the cable shield and ground by securing the stripped wire under the cable clamp.
102 | Danfoss A/S © 2021.10
4 Input power terminals (disconnect option is shown)
5 Grounding bar
AQ262139143212en-000301 / 130R0879
Electrical Installation