International/North American Default Parameter Settings - Danfoss D9h Operating Manual

VLT® AutomationDrive FC 302
Operating Guide
Term Definition
PELV Protective extra low voltage
PHF Passive harmonic filter
PID Proportional integral derivative
PLC Programmable logic controller
P/N Part number
PROM Programmable read-only memory
PS Power section
PTC Positive temperature coefficient
PWM Pulse width modulation
R Stator resistance
S
RAM Random-access memory
RCD Residual current device
Regen Regenerative terminals
RFI Radio frequency interference
RMS Root means square (cyclically alternating electric current)
RPM Revolutions per minute
SCR Silicon-controlled rectifier
SMPS Switch mode power supply
S/N Serial number
STO Safe Torque Off
T Torque limit
LIM
U Nominal motor voltage
M,N
V Volt
VVC Voltage vector control
X Motor main reactance
h

11.3 International/North American Default Parameter Settings

Setting parameter 0-03 Regional Settings to [0] International or [1] North America changes the default settings for some parameters.
Table 139: VLT FC Series International/North American Default Parameter Settings
®
Parameter
Parameter 0-03 Regional Settings
Parameter 0-71 Date Format
Parameter 0-72 Time Format
192 | Danfoss A/S © 2021.10
International default value
International
DD-MM-YYYY
24 h
Appendix
North American default value
North America
MM/DD/YYYY
12 h
AQ262139143212en-000301 / 130R0879