Connecting The Du/Dt Filter To The Motor - Danfoss D9h Operating Manual

VLT® AutomationDrive FC 302
Operating Guide
6. Tighten the terminals in accordance with the specifications shown in
Example
1
Illustration 59: Connection Points for the Sine-wave Filter to Motor (Top-exit Configuration Shown)
1 Motor terminals
2 Grounding bar

5.8.5 Connecting the dU/dt Filter to the Motor

Procedure
1. Strip a section of the outer cable insulation.
2. Fasten a connector/cable lug to the end of the stripped cable.
3. Create an electrical connection between the cable shield and ground by securing the stripped wire under the cable clamp.
4. Connect the ground cable to the nearest grounding terminal in accordance with the grounding instructions provided in
5.8.6 Connecting to
Danfoss A/S © 2021.10
Ground.
10.11 Fastener Torque
2
AQ262139143212en-000301 / 130R0879 | 105
Electrical Installation
Ratings.