HOLDEN XC Series Owner's Handbook Manual page 107

Tail, brake, rear turn signal,
reverse lamps (Barina)
1. Remove the two screws from the rear
lens assembly using a screwdriver.
2. Pull the lens assembly rearward to
disengage it from its locking elements.
3. Disengage the cable connector from
the lens assembly using a screwdriver
and remove it from the assembly.
4. Remove the four screws from the bulb
mounting, using a screwdriver, and
remove the bulb mounting from the lens
assembly.
Bulb sequence, from top to bottom:
Turn signal light
Brake light / tail light (two filaments)
Reverse light
5. Remove the bulb from the holder.
6. Insert the new bulb, engage the bulb
holder into the lens and install the
screws, as illustrated.
7. Engage the cable connector with the
lens assembly.
8. Align and insert the fixing pins of the lens assembly into the body holes and secure
the assembly with the two screws.
BULB REPLACEMENT cont.
Chapter 6
6-23
EMERGENCIES