Trunk Configuration Menu - Panasonic PN261693D Manual

4.2.2.

Trunk Configuration Menu

Press L (command) on the Advanced Switch Configuration menu, and then you can
see Trunk Configuration Menu as Figure 4-9. You can configure trunking on this
screen.
PNxxxxxx Local Management System
Advanced Switch Configuration -> Trunk Configuration Menu
System Priority
Key Mode
----- -------- ---------------------------------------------------------------
1 Manual 3-4
2 Active 5-6
-------------------------------- <COMMAND> -----------------------------------
Se[t] System Priority
[A]dd Group Member
[R]emove Group Member
[M]odify Group Mode
Command>
Enter the character in square brackets to select option
Screen Description
System Priority This means the priority level of this device, which is necessary for configuring
trunking on the network with LACP. The lower a numerical value is, the higher pri-
ority level will be. The factory default settings is set to one (1).
ID Displays the group number of trunking.
Mode Displays the operation mode of trunking.
Active
Passive
Manual
Member Port Displays the port belonging to a trunking group.
List
-------------------------------------------------------------------------------------------------------------------------------------------
Note: If the trunking mode is Passive between switches, a loop occurs without per-
forming the LACP negotiation. Be sure to configure Active for one side of the configu-
rations when configuring trunking with the LACP.
-------------------------------------------------------------------------------------------------------------------------------------------
: 32768
Member Port List
Set P[o]rt Priority
LACP [G]roup Status
[Q]uit to previous menu
Figure 4-9: Trunk Configuration Menu
The active mode outgoes LACP packets from this device, and con-
figures trunking by performing the negotiation with the opponent
side. The mode of the opponent side needs to be either Active or
Passive.
The passive mode does not outgo LACP packets from this device,
and configures trunking by performing the negotiation when
receiving LACP packets from the opponent side. The mode of the
opponent side must be Active.
Manual does not use LACP packets, and configures trunking force-
fully. The opponent-side needs to be configured, similarly.
85