Table of Contents
Advertisement
Screen Description
PPS Global
Displays the status PPS configuration.
Status
Enable
Disable
PPS Status
Displays the operation status (or condition) of the current PPS.
Stand Alone
CPNL
Controlled
PPS Start Status Displays the status of the initial operation when activating the PPS function.
Stand Alone
CPNL
Retry Count
Displays the number of times to retransmit (or resend) packets, which are
confirmed to exist. The factory default settings is three times.
Timeout
Displays the waiting time for the response to packets which are confirmed to
exist. The factory default settings is 5 seconds.
Controller ID
Displays an ID of the PPS controller.
Controller
Displays the time elapsed after activating the PPS controller.
Uptime
Controller
Displays the MAC address of the PPS controller.
MAC Address
PPS Gateway
Displays the MAC address of the PPS gateway.
Controller Port
Displays the port-number used for the communication with the PPS controller.
Expired
This means the time needed to delete the registration information on the
controller. The factory default settings is 120 seconds.
The following describes how to use several commands on this screen.
E
Configures to enable or disable PPS.
Press E (command), and then the appearance of the command prompt becomes "Enable
or Disable PPS global status (E/D) >". Press E to enable and D to disable it.
I
Specify (or designate) the ID of the PPS controller.
Press I (command), and then the appearance of the command prompt becomes "Enter
Controller ID>". Enter the ID of PPS controller. After that, the screen becomes "Set
Controller MAC address (Y/N) >"
After pressing Y, the screen becomes "Enter MAC Address(xx:xx:xx:xx:xx:xx) >". Enter the
MAC address of the PPS controller.
S
Configures the status of the initial operation for PPS.
Press S (command), and then the appearance of the command prompt becomes "Select
start status (C/S) >". Press S to set it to Stand Alone or C to CPNL.
N
Performs the notification settings for PPS.
Press N (command), and then the appearance of the screen becomes "PPS Notification
Configuration". The notification setting of PPS is possible. See 4.12.2 for the configuration
method in this situation.
PPS is enabled.
PPS is disabled (factory default settings).
This status means that it is not managed by the PPS controller.
CPNL is the abbreviation of Controller Port Neighbor Lost.
This is the condition, which cannot communicate with the
controller although the switching hub recognizes the controller.
The switching hub recognizes the controller, and is the condition
is communicable with the controller.
This status means that it is not managed by the PPS controller.
CPNL is the abbreviation of Controller Port Neighbor Lost. This is
the condition, which cannot communicate with the controller
although the switching hub recognizes the controller.
.
Press Y to configure the MAC address, and N otherwise.
162
Advertisement
Table of Contents
