Table of Contents
Advertisement
The following describes how to use several commands on this screen.
N
Displays the next page.
Press N (command) to display the next page.
P
Displays the previous page.
Press P to display the previous page.
S
Sets the value of System Priority of this device on LACP.
Press T, and then the appearance of the command prompt becomes "Enter system priority
for LACP>". Enter the priority value.
A
Configures trunking newly.
1. Press A, and then the appearance of the command prompt becomes "Enter trunk group
admin key>". After that, enter the group number to be configured.
2. The appearance of the command prompt becomes "Enter port member for group key
#>. Then enter the port-number to operate the trunking. Specify the hyphen for the con-
secutive numbers or delimit with a comma and no spaces when entering two or more
port-numbers.
3. The appearance of the command prompt becomes "Lacp Active, Lacp Passive or
Manual trunk setting(A/P/M)>". Select A to set the operation mode to Active, P to
Passive, and M to Manual.
R
Deletes the configuration of trunking.
1. Press R, and then the appearance of the command prompt becomes "Enter trunk
group admin key>". Enter the group number to be deleted.
2. The appearance of the command prompt becomes "Enter port member port for group
key #>". Then enter the port-number to operate the trunking. Specify the hyphen for
the consecutive numbers or delimit with a comma and no spaces when entering two or
more port-numbers.
M Changes the operation mode of trunking.
1. Press M, and then the appearance of the command prompt becomes "Enter trunk
group admin key>". After that, enter the group number to be changed.
2. The appearance of the command prompt becomes "Lacp Active, Lacp Passive or
Manual trunk setting(A/P/M)>". Then select A to set the operation mode to Active, P
to Passive, and M to Manual.
O
Sets the priority value per port of this device on trunking.
Press O, and then the appearance of the screen becomes "Set port Priority". See next
section (4.2.3) for the method of advanced settings.
G
Displays the condition of an LACP group.
1. Press G, and then the appearance of the command prompt becomes "Enter trunk
group number >". Enter the key of a group to be displayed. (The content to enter here
is limited to the mode, which is either Active or Passive group.)
2. The appearance of the screen becomes "LACP Status". See next section (4.2.4) for this
content.
Q
Returns to the top menu.
-------------------------------------------------------------------------------------------------------------------------------------------
Note: Regarding members, this device can configure up to 24 ports for one group, but
can operate trunking up to eight (8) ports. Members of the group, after the ninth port,
become the backup mode. If a failure occurs in the link up to the eighth port, the
members configure trunking instead of the port. In this case, the value of the port pri-
ority configured on next section (4.2.3) determines the priority, which can become
members. If the priority value is the same for all, the trunking becomes configured
from the lower port-number.
-------------------------------------------------------------------------------------------------------------------------------------------
86
Advertisement
Table of Contents
