Panasonic PN261693D Manual page 81

The following describes how to use several commands on this screen.
N Displays the next page.
Press N (command) to display the next page.
P Displays the previous page.
Press P to display the previous page.
V Configures Trunking Native VLAN.
Press V, and then the appearance of the command prompt becomes "Enter port-
number>". Enter the port-number to be configured. Press 0 to configure all the ports. After
that, the appearance of the command prompt becomes "Enter VLAN ID>". Then enter a
VLAN ID to be configured for Trunking Native VLAN.
A Adds VLAN ID for Trunking VLANs.
Press A, and then the appearance of the command prompt becomes "Enter port-number>".
After that, enter the port-number to be configured.
Press 0 to configure all the ports. After that, the appearance of the command prompt
becomes "Enter VLAN ID>". Enter a VLAN ID to add it on trunking VLANs. Create a VLAN
ID to add it in VLAN Management Menu in advance.
R Deletes a VLAN ID from Trunking VLANs.
Press R, and then the appearance of the command prompt becomes "Enter port-number>".
After that, enter the port-number to delete VLAN ID. Press 0 to configure all the ports. After
that, the appearance of the command prompt becomes "Enter VLAN ID>". Enter the port-
number to delete it from Trunking VLANs.
G Configures the GVRP status.
Press G, and the appearance of the command prompt becomes "Enter port-number>". After
that, enter the port-number to be configured. Press 0 to configure all the ports. After that,
the appearance of the command prompt becomes
E to enable and D to disable it.
Q Returns to the top menu.
-------------------------------------------------------------------------------------------------------------------------------------------
Note: This device can provide (or assign) two or more VLANs with one port. If VLAN is
newly configured, the device belongs to both VLAN (which used to belong before) and
new VLAN. Be sure to delete it from the VLAN, which has been belonging to, when
dividing domains is necessary.
-------------------------------------------------------------------------------------------------------------------------------------------
"
Enable or Disable (E/D)>". Then press
81