Table of Contents
Advertisement
The following describes how to use several commands on this screen.
N
Displays the next page.
Press N (command) to display the next page.
P
Displays the previous page.
Press P to display the previous page.
U
Set the threshold of Unicast.
1. Press D, and then the appearance of the command prompt becomes "Enter port-
number>". Enter the port-number to be specified.
2. The appearance of the command prompt becomes "Select threshold value mode >".
Press 1 to select pps, 2 to select kbps, and 3 to select ratio.
3. The appearance of the command prompt becomes "Enter threshold value>". In the
case of designating pps, enter that in the range from 0 to 1,488,100. In the case of des-
ignating kbps, enter in the range from 0 to 1,000,000. In the case of designating ratio,
enter in the range from 1 to 100.
B
Set the threshold of Broadcast.
1. Press B, and then the appearance of the command prompt becomes "Enter port-
number>". Enter the port-number to be specified.
2. The appearance of the command prompt becomes "Select threshold value mode >".
Press 1 to select pps, 2 to select kbps, and 3 to select ratio.
3. The appearance of the command prompt becomes "Enter threshold value>". In the
case of designating pps, enter that in the range 0 and 1488100. In the case of
designating kbps, enter in the range from 0 to 1,000,000. In the case of designating
ratio, enter in the range from 1 to 100.
M Set the threshold of Multicast.
1. Press M, and then the appearance of the command prompt becomes "Enter port-
number>". Enter the port-number to be specified.
2. The appearance of the command prompt becomes "Select threshold value mode >".
Press 1 for selecting pps, 2 for kbps, and 3 for ratio.
3. The appearance of the command prompt becomes "Enter threshold value>". In the
case of designating pps, enter that in the range from 0 to 1,488,100. In the case of
designating kbps, enter in the range from 0 to 1,000,000 . In the case of designating
ratio, enter it in the range from 1 to 100.
S
Set the Storm Control Action.
1. Press S, and then the appearance of the command prompt becomes "Enter port-
number>". Enter the port-number to be specified (or designated).
2. The appearance of the command prompt becomes "Select port action type (D/N/S)>".
Press D to delete the packets, which exceed the upper threshold, N if filtering is not per-
formed, and S to shut down a port.
Q
Returns to the top menu.
116
Advertisement
Table of Contents
